|
As can be seen here the off side holes were further apart. This then had to be filled to meet the new rear clip. |
|
Masking tape was placed on the surrounding body and bridgeing compound used to fill the gap. As this started to go off the tape was removed to reduce the amount of sanding. |
|
Once fully hardened the rear point was then sanded flush and shaped as before. I also tied a small length of string to the wires so I could push them in the wing without being lost. |
|
Success, New indicator clips into place like it was made for the job. Now just a bit a wet and dry and soldering the wires is needed.
Total time was just over an hour. |
|
Wider Shot of near side. The new indicators are slightly taller but not as long and about half the depth (dont stick out as far). |
